Acrosser AR-ES5430FL User Manual

Revision :1.1 1 Revision Description Date 1.0 Release 2008/01/29 1.1 Add new system dimension 2009/06/16 1.11 Change new RS-

Revision :1.1 102-2 Installing CF card The following are procedure for install CF card 1. Remove screws (2pcs) in CF card bracket 2. Install CF

Revision :1.1 11 2-3 Installing SO-DIMM The following are procedure for install SO-DIMM 1. Remove HDD out from the system 2. Install the SO-DIMM

Revision :1.1 123. Re-Install HDD device 4. Lock the bottom case Door screws 2-4 Installing the 2.5”SATA Hard Disk Drive(HDD)(Option) The foll

Revision :1.1 132. Lock HDD and Bracket together via screws (4pcs) 3. Plug the HDD cable into the power and signal header connectors in main bo

Revision :1.1 144. Remove right side door screws (2pcs) in system bottom case 5. Route the HDD cable through the main board 6. Lock right si

Revision :1.1 152-5 Change from RS232 to RS422/485 by using Y-cable 1. Remove the 4 screws from top cover. 2. Slide the top cover in the

Revision :1.1 16 4.Change by this terminal to connect with the RS422/RS485 pin header of main board.(Appendix A) 5. Slide the top cover and cl

Revision :1.1 17 6. Tighten the original screws.

Revision :1.1 18APPENDIX A COM2 => RS232 (PIN1, Please refer to the AR-B5430 User’s Manual) J5 => RS422/485(PIN1, Please r

Revision :1.1 2Contents 1 Introduction to AR-ES5430FL………………………………………..3 1-1 Description……………………………………………………….…3 1-2 Packing List………………………………………

Revision :1.1 31. Introduction to AR-ES5430FL AR-ES5430FL is a system product mainly for ticket control, navigation, advertising, fleet managem

Revision :1.1 41.3 Main system (1) Dimension

Revision :1.1 5(2) System Configure

Revision :1.1 62. Procedure of Assembly/Disassembly 2-1 Installing the 2.5” Hard Disk Drive (HDD) The following are procedure for install 2.5”H

Revision :1.1 72. Lock HDD and Bracket together via screws (4pcs) 3. Plug the HDD cable into the 44-pin header connectors in main board

Revision :1.1 84. Remove right side door screws (2pcs) in system bottom case 5. Route the HDD cable through the main board 6. Lock right si

Revision :1.1 9 7. Lock HDD bracket to the top case by four screws 8. Insert HDD cable into the HDD module 9. Lock the door screws in system